pg. 14
Figure 6 – Machine Name Screen
3. Configure Wi-Fi: Select the appropriate SSID (Wi-Fi Network Name) to allow connectivity to
the DataSmart server. Enter the password and press OK to save. An active Wi-Fi connection
is required to complete this step and to initialize the unit. If the DataSmart machine is unable
to connect to a Wi-Fi network, it is recommended to turn the power off, then re-start the
machine and return to the Configure Wi-Fi step. If no password is required for the WiFi
network, then press ENTER at the password screen to bypass this requirement. The unit
cannot access a WiFi network that requires a terms of use acknowledgement, even if no
password is required. Adding the MAC Address to the WiFi network can help facilitate
connection.
Figure 7 – WiFi Setup
4. Registration Code: Enter the registration code that was provided as part of the DataSmart
agreement. Press OK to save. The unit will contact the DataSmart server to validate the
code. Depending on your internet connection speed, it may take several minutes to
complete this step.
To Next Page
Loading...
