pg. 4
• Always test cylinders to be sure the cylinders are full before connecting to a manifold. All gas distribution
piping systems must meet the appropriate industrial standards for the intended service and must be thoroughly
cleaned before using. For the United States, some applicable safety rules and precautions are listed below:
1. American National Standards Institute standard Z49.1, Safety in Welding and Cutting, American
Welding Society, 2501 NW Seventh Street, Miami, Florida 33125
2. N.F.P.A. Standard 51, Oxygen-Fuel Gas systems for Welding and Cutting, N.F.P.A., 470 Atlantic
Avenue, Boston, Massachusetts 02210
3. N.F.P.A. Standard 51B, Cutting and Welding Processes (same address as #2).
4. Local Ordinances
5. O.S.H.A. Standard 29 CFR
6. C.G.A. Pamphlet C-4, American National Standard Method of Marking Portable Compressed Gas
Containers to Identify the Material Contained.
7. C.G.A. Pamphlet G-4, Oxygen – Information on the properties, manufacture, transportation, storage,
handling, and use of oxygen.
8. C.G.A. Pamphlet G-4.1, Equipment Cleaned for oxygen service.
9. C.G.A. Pamphlet G-4.4, Industrial Practices for Gaseous Oxygen Transmission and Distribution
Piping Systems. 10. C.G.A. Pamphlet G-5, Hydrogen – Information on the properties, manufacture,
transportation, storage, handling, and use of hydrogen.
11. C.G.A. Pamphlet G-6, Carbon Dioxide – Information on the properties, manufacture, transportation,
storage, handling, and use of carbon dioxide.
12. C.G.A. Pamphlet G-6.1, Standard for Low Pressure Carbon Dioxide Systems at Consumer Sites.
13. C.G.A. Pamphlet P-1, Safe Handling of Compressed Gases in Containers. 15. C.G.A. Safety
Bulletin SB-2, Oxygen Deficient Atmospheres. C.G.A. Pamphlets can be obtained from the
Compressed Gas Association, 3
USER RESPONSIBILITY
Service to this product should only be performed by HARRIS PRODUCTS GROUP.. Requests for service may
be made through HARRIS CUSTOMER SERVICE. HARRIS accepts no responsibility for damage or injury if
this product is modified in any way. HARRIS assumes/accepts no liability or responsibility for damage to
individuals or equipment that may occur when using this product.
To Next Page
Loading...
Need help?
General
