23
Splash Screen
This screen is displayed every time the system starts up.
*Note* Actual Model name will change – this is a placeholder
Initial Setup/Configuration
On the initial startup, the system will prompt the user to set the Machine Name, select a Wi-Fi network, validate the
registration code for the subscription, and set the operation mode parameters. The system will not allow the user to
proceed until all steps are complete.
If the master QA code(AMS$QT#2019) is entered as the Machine Name, this will bypass the remaining steps and allow
the system to be used with full functionality for quality testing (QA mode) during manufacture. In this scenario:
The system serial number is entered and saved to memory
Wi-Fi is set independent of any setup process
The basic functionality of the system is tested with the use of a master password to access controlled areas
Master password is set on the system using the system serial number
QA mode can only be used once. After powering down while in QA mode, the system resets and loads the initial
configuration wizard upon next power-up.
If the Erase Code/Password(HPG$ERASE#NFLASH) is entered as machine name then it will erase the entire machine
setting along with the Log data. In this scenario user have to reconfigure the entire system
To Next Page
Loading...
