47
Operation Mode will display the configuration settings as set by the user: Priority; Gas Source for each bank. A graphic
will display for each bank that wil correspond to the approximate available gas in each bank: 0-20%; 21 – 40%; 41-60%;
61-80%; 81-100%. The active indicator will only be displayed if the bank is active; otherwise it will be hidden (right side
shown as grey in this graphic for placement purposes only).
If the system is shut down, the user will be returned to the Operation Mode screen when it is restarted, using the same
operating configuration that was in place at the time of shutdown.
If the user presses EDIT or SYSTEM CONFIG, they must use a user name/password combination to authenticate.
During the initial system setup, configuration values can be set without entering any credentials. After that initial setup
is complete, the user must log in. User accounts will be set up through the web application, and will be pushed to the
machine when saved in the web interface. The machine will store this user information (maximum of 10 users per any
individual machine), and will authenticate using the local stored information.
Machine will have the default local user name and password stored in machine itself, user can change the default local
user name and password if necessary. After the change of user name and password the default user name and password
cannot be used. If the user forget the local user name and password then the default local user name and password can
be retried by entering the wrong user name and password 10 times.
The user name and password setup at web application will not be stored in the machine, but those user name and
password are accessible in the machine through web application.
Default Local UserName: HPG_AMS
Default Local Password: HPG@123
To Next Page
Loading...
