6-10 888-2586-001 9/15/06
WARNING: Disconnect primary power prior to servicing.
Platinum Z16HD+
Section 6 Troubleshooting
•Flow Control = None
•Emulation = VT100
STEP 5 Call, or hit "Enter" twice to initiate handshake
To navigate around the VT100 screens:
•Left/Right arrows to page back/forward
•Up/Down arrows to move cursor within page
To edit a numerical entry:
STEP 1 Type the line number or letter in parenthesis - do NOT hit "Enter"
STEP 2 Use up/down arrow keys to increase/decrease numerical value
(with the exception of the Meter Calibration section, where it is required
to type in the numerical value)
STEP 3 Press the "Enter" key to store that entry
To toggle (turn on/off) a command:
STEP 1 Type the corresponding number or letter in parenthesis - do NOT hit
"Enter"
STEP 2 Type the same number or letter again to toggle that command
To Next Page
Loading...
