9/15/06 888-2586-001 2-7
WARNING: Disconnect primary power prior to servicing.
Section 2 Installation & Initial Turn-On
Platinum Z16HD+
STEP 6 Carefully slide exisiting exciter or IP1D/IP2D out of cabinet
STEP 7 Use existing rails to slide new unit into cabinet
STEP 8 Refer to "2.5.4.4 BoostPro Connections" on page 2-7
2.5.4.3 Add-on Installation
STEP 1 If being installed as an addition, remove blank panels of the Z
transmitter cabinet
STEP 2 Install rack rail frame
STEP 3 Slide unit onto rack rail guides
STEP 4 Refer to "2.5.4.4 BoostPro Connections" on page 2-7
Figure 2-1 BoostPro Rear Panel
2.5.4.4 BoostPro Connections
IMPORTANT:
Refer to System Configuration drawings in the FlexStar System technical manual
(888-2587-001) for cable numbers and routing options for your configuration.
2.5.4.4.1 AC Input
Connect AC source to 3-prong receptacle on rear panel.
To Next Page
Loading...
