HART HLPM02 - Troubleshooting

11 – English
TROUBLESHOOTING
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.
PROBLEM POSSIBLE CAUSE SOLUTION
Handlenotinposition. Handleadjustmentknobsand/orhandle
lockclipsarenotsecured.
Make sure handle adjustment knobs
are fully seated and handle lock clips
arefullyclosed.
Mowernotstarting. Batteryislowincharge.
Startkeynotinstalled.
Handle assembly is not in operating
position.
Chargethebattery.
Installstartkey.
Raiselowerandupperhandle.
Mowercuttinggrassunevenly. Lawn is rough or cutting height not set
properly.
Adjustthecuttingheight.
Mowernotmulchingproperly. Wet grass clippings sticking to the
undersideofthedeck.
Waituntilthegrassdriesbeforemowing.
Mowerhardtopush. High grass, rear of mower housing and
bladedragginginheavygrass,orcut-
tingheighttoolow.
Raisecuttingheight.
Mowernotbaggingproperly. Cuttingheightsettoolow. Raisecuttingheight.
Mowervibratingathigherspeed. Blade is unbalanced, excessively or
unevenlyworn.
Bentmotorshaft.
Replacetheblade.
Stopthemotor,removestartkeyand
battery. Inspect for damage. Have
repairedbyanauthorizedservicecenter
beforerestarting.
Motorstopswhilecutting. Cuttingheightsettoolow. Raisethecuttingheight.