HART HTMS01 - Page 5

5 – English
 Make sure the miter table and saw arm (bevel func-
tion) are locked in position before operating your saw.
Lockthemitertablebytighteningthemiterlockknob.
Lockthesawarm(bevelfunction)bysecurelytightening
thebevellockknob.
 Never move the workpiece or make adjustment to any
cutting angle while the saw is running and the blade
is rotating. Anyslipcanresultincontactwiththeblade
causingseriouspersonalinjury.
 Avoid awkward operations and hand positions wherea
suddenslipcouldcauseyourhandtomoveintotheblade.
ALWAYS make sureyou have good balance. NEVER
operate yourmitersawonthe floor or in acrouched
position.
 Never standorhaveanypartofthebodyinlinewiththe
pathofthesawblade.
 Do not turn the motor switch on and off rapidly. This
couldcausethesawbladetoloosenandcouldcreate
ahazard.Shouldthiseveroccur,standclearandallow
thesawbladetocometoacompletestop.Disconnect
yoursawfromthepowersupplyandsecurelyretighten
thebladebolt.
 If any part of this miter saw is missing orshouldbreak,
bend,orfailinanyway,orshouldanyelectricalcompo-
nentfailtoperformproperly,shutoffthepowerswitch,
removethemitersawplugfromthepowersourceand
havedamaged,missing,orfailedpartsreplacedbefore
resumingoperation.
 Always turn off the saw beforedisconnectingittoavoid
accidentalstartingwhenreconnectingtopowersupply.
NEVER leavethesawunattendedwhileconnectedtoa
powersource.
 This tool shouldhavethefollowingmarkings:
 • Toreducetheriskofinjury,usermustreadtheopera-
tor’smanual.
 • Weareyeprotection.
 • Keephandsandbodyoutofthepathofthesawblade.
Contactwiththebladewillresultinseriousinjury.
 • Checkguardingsystemtomakesureitisfunctioning
correctly.
 • Donotperformanyoperationfreehand.
 • Neverreacharoundthesawblade.
 • Turnofftoolandwaitforsawbladetostopbeforemoving
workpieceorchangingsettings.
 • Disconnectthesawfromthepowersourcebeforechang-
ingbladeorservicing.
 Always carrythetoolonlybythecarryinghandleareas.
 This saw can tip overifthesawheadisreleasedsud-
denly andthesawis not securedtoa work surface.
ALWAYSsecurethissawtoastableworksurfacebefore
anyusetoavoidseriouspersonalinjury.
 Always make sure the saw blade has clearance of all
obstructions before turning the saw on.
ADDITIONAL SAFETY RULES