26
To take measurements in guest mode, start
the measuring procedure by simultaneously
pressing both memory keys, and . Do not
press the START/STOP button . During and
after the end of the measurement, the two
symbols and appear simultaneously on
the display next to the measured values. The
result can thus not be assigned to either
person and the measured values will not be
saved.
The device is also switched off in guest mode by pressing the START/STOP
button . Otherwise the device will switch itself off automatically after
3minutes.
6. Memory function
User memory
Veroval
®
duo control stores up to 100measurements for each user memory.
The most recent measurement is always saved together with the date and time
in memory slot no.1 and all older saved values are moved up one memory
slot. Once all memory slots are occupied, the oldest value is deleted.
The device has two memory keys, and , that are used to record the
measurement results for two separate users. represents the measured
values for the first user, represents the measured values for the second
user. When a beep indicates the end of measurement, you can assign the
measured value to the respective person by pressing or . This assignment
can be made for as long as the values are displayed. If you do not assign
them, the measured value is automatically stored in the user memory that is
currently displayed.
The time of the measurement is also saved, along with each of the blood
pressure values, to enable the morning and evening averages to be
determined. The time saved in the device must therefore be set correctly to the
actual time (see Chapter4 ‘Setting the date and time‘).
Veroval
®
duo control features the following measurement data storage functions
(corresponding to the ESH – European Society of Hypertension – guidelines)
• Individual measured value memory
IFU_Veroval_dc_SK6_0307662_2020-02-10.indd 26 27.02.20 13:08
To Next Page
Loading...
Need help?
General
