33
Switch the monitor off if an error message appears.
Check for all possible causes and follow the 10 golden rules (Chapter5.1)
as well as the instructions for self-measurement from Chapter2 ‘Important
information‘.
Relax for 1minute and then repeat the measurement.
9. Device care
Only ever use a soft, damp cloth to clean the monitor. Please do not use
thinners, alcohol, cleaning agents or solvents.
The cuff can be cleaned carefully using a slightly damp cloth and mild soap
solution. Do not completely immerse the cuff in water.
It is recommended that the cuff be cleaned and disinfected regularly or after
each use, especially when used by several users, to prevent infection. The cuff
should be disinfected, particularly on the inside, by wiping with a disinfectant.
To disinfect the device and the cuff, 70% isopropyl alcohol solution (active
substance: 2-propanol) can be used. Other suitable specific disinfectants are
listed on our website (Chapter12).
To protect the device from external influences, you can store the device and
the cuff in the storage bag, together with these instructions.
10. Accessories
To ensure measuring accuracy, only use original HARTMANN accessories
which can be obtained from your pharmacist or specialist medical supplier.
Accurate measured results cannot be guaranteed outside the upper-arm
circumference ranges specified here.
Standard cuff, medium, for upper arm circumference of 22– 32cm
Art. no. 925 531
Standard cuff, large, for upper arm circumference of 32– 42cm
Art. no. 925 532
Mains power operation: on the rear of the device there is a socket for the
adapter for mains operation (output 6V DC/600mA). Please only use the
Veroval
®
power supply unit (model no. 925 391). Otherwise, the function and
measuring accuracy of the monitor cannot be ensured.
IFU_Veroval_dc_SK6_0307662_2020-02-10.indd 33 27.02.20 13:09