30
Error Possible causes Remedy
Air is released too fast or too
slow during the measuring
procedure.
The cuff could have become
detached or loosened.
Movement during the
measuring procedure could also
be the reason.
Error during air release or
unusual pressure reduction.
Check whether the cuff has
been positioned correctly.
Do not move during the
measurement.
Air tube is not correctly inserted
into the device or is kinked.
Check that the connector is
correctly fitted and for kinks in
the air tube.
The inflation pressure is higher
than 300 mmHg.
The pressure is released
automatically.
Repeat the measurement after
at least 1 minute of rest.
If the battery symbol is
flashing, the batteries are
almost empty. Only a few more
measurements are possible.
Have new batteries of the same
type ready (AA/LR06).
If the battery symbol is
permanently displayed, the
batteries are empty and have to
be replaced.
Insert new batteries of the
same type (AA/LR06). Then
check the date/time and, if
necessary, reset them (see
Chapter 4).
Implausible
measured values
Implausible measured
values often occur due to
inappropriate handling of
the device or if there are
mistakes during the measuring
procedure.
Please note the 10 golden
rules for blood pressure
measurement (see Chapter 5.1)
as well as all the important
instructions in Chapter 2.
Then repeat the measurement.
If implausible values still occur:
please contact your doctor!
IFU_Veroval_dc_SK2_0307661_EN_TR_AE_CN_200918.indd 30 17.10.18 18:04
To Next Page
Loading...
Need help?
General
