17
the display.
(3) The auto-close function is disabled when the auto-close time is 0.
(4) Press the SET button to confirm and exit.
4.5 Gate lock function
The gate lock function (LOCK system) protects against accidental opening (e.g. after putting the
remote control in your pocket). After activating this function, the gate can be opened only after
pressing the lock button on the remote control (it is a button that cannot be programmed to operate
the drive - button code 3), and then the appropriate button (directly after itself). To activate the gate
lock function:
(1) Press and hold the SET button, the display will show a number from 1 to 4. Release the
button. The display will show '' 0 '' or '' 1 ''.
(2) Press the UP button, the display will show the number 1 - the door locking function is
active. Press the DOWN button, the display will show the number 0 - the blocking function
is inactive.
(3) After setting the correct option, press the SET button and the system enters the normal
operation mode.
4.6 Programming the remote control
• Press the LEARN button - a dot will light up on the display. Then press the selected button on
the remote control twice. The dot should blink and the drive will go into normal operation.
The button on the remote control has been programmed.
• Repeat the above for all remotes. You can program up to 20 transmitters or buttons.
• To clear all memorized remotes, press and hold the LEARN button for more than 8 seconds
until the display shows C. All remotes have been cleared.
• The button code 3 cannot be used to operate the drive - it serves only for the blocking
function (the button generating the code 3 may be described differently on the remote
control housing).
4.7 Final steps
• Check that all bolts and nuts are tightened.
• Check that the control button and the emergency release knob are installed above a height
of 1.5 meters
• Check that the installation has been carried out in accordance with the applicable regulations
• Check the effectiveness of the safety and control devices.
• Check the balance of the garage door leaf.
• Carry out multiple attempts to close and open the garage door to make sure that all
mechanisms are working properly. Maintain the ratio of working time to rest time in the
proportion of 1: 2. Operating the drive without adequate idle time may result in damage.
• Check the effectiveness of the protective circuit of the residual current system.
• Mark the garage door with appropriate signs in potentially dangerous places.
• Stick a sticker on the door in a visible place with the text Warning!
To Next Page
Loading...
