HATO 200 - Page 20

20
accordance with the instructions
and standards.
When closing, the gate
stops suddenly and moves
backwards
1. Increased resistance to
door sliding
1. Unblock the drive and, by
manually moving the gate, check
that the gate moves easily and that
it is well balanced with springs.
2. Insufficient drive force
2. Set the correct drive force in
accordance with the instructions
and standards.
When closing the door,
the drive does not react
to the obstacle in the light
of the photocells
Incorrect photocells
If the gate is open and we cover
the photocells, the gate will not
close, and if the gate does not
respond to an obstacle, it means
that the photocells are not
compatible with the drive. Suitable
photocells for the HATO 200 model
must be used
The drive moves the gate
in steps of a few
centimeters
Engine speed sensor
defective.
Send the drive to the service with a
description of the fault and the
purchase document
The remote control does
not work
1. Battery discharged
1. Replace the battery
2. The remote control is not
logged into the drive
2. Log in the remote control
according to the instructions
3. Faulty remote control
3. Send the remote control to the
service together with a description
of the fault and the purchase
document
The range of the remote
control is too small
1. Drive located in a steel or
reinforced concrete garage
1. Installation of an external
antenna by a specialist
2. Battery running low
2. Battery replacement
3. Faulty remote control
3. Send the remote control to the
service together with a description
of the fault and the purchase
document
4. Defective radio module in
the drive
4. Send the drive to the service
together with a description of the
fault and the purchase document
After a power failure and
restarting, the drive
automatically moves the
gate
1. Wrong type of wall switch
to control the door
1. To control the gate with a wall
button, a "bell" type button with
normally open contacts should be
used. Replace the button with the
correct one.
2. Defective microcontroller
2. Send the drive to the service
with a description of the fault and
the purchase document
Other problem
Other causes
Send the drive to the service with a
description of the fault and the
purchase document.