Assembling:
– Drive in locking collet (181/1) until it
projects by 10.5 mm.
– Insert spring (181/2) into fork (181/3)
and push on to control shaft.
– Drive locking collet (181/4) in flush with
the fork and connect the spring to it by
using a suitable tool.
– Continue installation by following the re-
moval instructions in the reverse order.
Note:
Since there are various patterns of gover-
nor lever, make sure when repairing the
speed control that the original governor
lever is installed again.
If the governor lever or the complete
speed control is renewed, note that torque
equalisation may have been activated at
the original governor lever.
In case of doubt, contact your nearest
HATZ service point.
3
L / M . . 09.96
181
To Next Page
Loading...
