Maintenance 2L41C, 2M41, 2M41Z
60
HATZ
Operator’s Manual
Draining the oil
Step Activity
1 Unscrew the oil drain screw (1) and drain the oil entirely.
When unscrewing the oil drain screw (1) on engines of type
2L41C, ensure that the drain pipe (2) is not loosened. Hold it
with an open-end wrench.
2 Screw in the cleaned oil drain screw (1) with the new gasket
and tighten.
Overview — Checking oil level/adding oil
Pos. Designation
1 Dipstick
2 Code letter on the dipstick
Procedure — Adding oil
Step Activity
1 Add engine oil to the max. mark on the dipstick(1).
▪ For the specification and viscosity, see chapter 4.4 Engine
oil, page 24.
▪ The code letter on the dipstick (2) indicates whether the en-
gine is equipped with an oil sump or not (see chapter 4
Technical data, page 21).
2 Reinsert the dipstick (1).
3 After a short test run, check the oil level and correct it if neces-
sary (see the chapter 7.8 Checking the oil level and adding oil
if necessary, page 47).
To Next Page
Loading...
