Hatz 2M41 - Page 86

Faults 2L41C, 2M41, 2M41Z
86
HATZ
Operator’s Manual
Type of fault Possible causes Remedy Chapter
▪ Oil is too vis-
cous.
8.2.5
Change the
engine oil,
page 59
▪ Insufficiently
charged battery.
Check the battery
and contact the
service center if
necessary.
3.2.4 Elec-
trical equip-
ment, page
18
The machine is not
uncoupled.
If possible, sepa-
rate the engine
from the machine
by uncoupling it.
The starter does
not switch on and
the engine does
not turn.
Irregularities in the
electrical equip-
ment:
▪ Battery and/or
other cable con-
nections are in-
correctly con-
nected.
▪ Cable connec-
tions are loose
and/or oxidized.
▪ Battery is faulty
and/or not
loaded.
▪ Faulty starter.
▪ Faulty relay,
monitoring ele-
ments, etc.
Check the electri-
cal equipment and
their components.
Contact Hatz ser-
vice.
3.2.4 Elec-
trical equip-
ment, page
18
The engine starts,
but does not con-
tinue running after
the starter is
switched off.
The speed control
lever is not suffi-
ciently set to the
Start direction.
Set the lever to the
Start position.
7.5 Starting
the engine,
page 35
The machine is not
uncoupled.
If possible, sepa-
rate the engine
from the machine
by uncoupling it.