462 4001055250 E 10.21 USA / GB
Turntable
Coolant level
MP0031
4 - You will need
5 - Procedure
• Position the machine on a flat and firm surface, clear of obstructions (beware of power lines).
• Put the machine in stowed position, boom and arm fully retracted and lowered.
• Personal protective equipment
• Standard tool kit
• "DO NOT OPERATE" tag
• Coolant -37°, Can 25L - 4000564860
• Place barriers around the perimeter of the work area
1 person
Before unscrewing the cooling system filler cap, shut off the
engine and wait for the parts of the cooling system to cool down.
Then slowly unscrew the cooling system filler cap to release the
pressure :
• Check that the cooling liquid sits between the maximum ( 1 ) and
minimum ( 2 ) levels of the expansion vessel.
• If the cooling liquid level is too low, find out why this is the case.
Case 1 :
Evaporation has lowered the cooling liquid level: top up with
clean fresh water only.
Case 2 :
A leak has lowered the cooling liquid level: top up with a cooling
liquid with the same brand and reference number using the
recommended mixing ratio (clean fresh water and L.L.C.).
If it is not possible to identify the brand of coolant, drain it and add
a new coolant mixture.
To Next Page
Loading...
Need help?
General
