20
www.coreservice.co.uk
Hotline: +44 01904 947568
Email support@coreservice.co.uk
When bucking on a slope always stand on the uphill side of the
log, as illustrated in Figure 6. When “cutting through”, to maintain
complete control release the cutting pressure near the end of the
cut without relaxing your grip on the chain saw handles. Don’t let
the chain contact the ground. After completing the cut, wait for the
saw chain to stop before you move the chain saw. Always stop the
motor before moving from tree to tree.
Figure 6
Safety Warning For Battery Pack
• Fully charge battery pack before the first use.
• Recharge battery pack when the power output starts to slow. Do
not continue to use product when battery capacity level is low.
• To prevent serious damage to the battery pack, charge in
temperatures above 5°C or below 45°C. Longest life and best
performance can be achieved when battery is charged at room
temperature (20 °C ± 5 °C).
• If the battery temperature is hot after use, it must be allowed to
cool before putting it into the charging station.
• If the battery pack becomes too hot during charging, disconnect
and switch off immediately. Contact the service center directly.
• Do not dismantle, open or shred cells or battery pack.
To Next Page
