19
www.coreservice.co.uk
Hotline: +44 01904 947568
Email support@coreservice.co.uk
When the log is supported on one end, as illustrated in Figure 4, cut
1/3 the diameter from the underside (underbuck) (1). Then make the
finished cut by overbucking (2) to meet the first cut.
2
2/3
1
1/3
Figure 4
When the log is supported on both ends, as illustrated in Figure
5, cut 1/3 the diameter from the top (overbuck) (1). Then make the
finished cut by underbucking (2) the lower 2/3 to meet the first cut.
1
2
1/3
2/3
Figure 5
To Next Page
