32
www.coreservice.co.uk
Hotline: +44 01904 947568
Email support@coreservice.co.uk
To obtain the best life from the battery
1. Never allow the battery to completely discharge before recharging. The battery pack should be
placed on the charger whenever the battery pack is noticeably running down or the tool no longer
performs a task it previously performed.
2. Avoid conducting short charges. Make sure that the battery is fully charged each time by allowing
the charger to complete its full charging cycle.
3. Avoid allowing loose items like screws or nails etc. to be stored with battery packs as these or
similar items can short battery packs and cause a fi e or explosion
4. Always unplug the charger when not in use and store in a dry and secure place.
5. Avoid charging or storing your battery in temperatures below 5°C and above 45°C.
6. After use, allow the battery pack to cool down for approximately 30 minutes before attempting to
recharge.
Installing or removing battery
CAUTION: Always switch off the tool before installing or removing of the battery
packs.
CAUTION: Hold the tool and the battery packs firmly when installing or removing
battery packs. Failure to hold the tool and the battery packs firmly may cause them to slip
out of your hands and result in damage to the tool and battery packs and a personal injury.
1
2
1.Release button 2.Battery pack
To remove the battery pack, slide it from the tool while depressing the release button on the front of
the battery pack. To install the battery pack, align the ribs on the battery pack with the groove in the
battery port and slip it into place. Insert it all the way until it locks in place with a click.
To Next Page
Loading...
