37
www.coreservice.co.uk
Hotline: +44 01904 947568
Email support@coreservice.co.uk
Lubrication
IMPORTANT: The chain saw is not filled with oil.
It is essential to fill with oil before use. Never operate the chain saw without chain oil or at an empty
oil tank level, as this will result in extensive damage to the product.
NOTE: Chain life and cutting capacity depend on optimum lubrication. The chain is automatically
oiled during operation.
Saw chain is automatically lubricated when the tool is in operation. Check the amount of remaining oil
in the oil tank periodically.
To refill the tank, lay the chain saw on its side and remove the oil tank cap. The maximum amount of
oil is 200 ml. After refilling the tank, make sure that the oil tank cap is tightened securely.
Oil level indication
window
Tank cap
After refilling, hold the chain saw away from the tree. Start it and wait until lubrication on saw chain is
adequate.
WARNING: Remove the battery pack before filling the oil tank.
To Next Page
Loading...
