36
www.coreservice.co.uk
Hotline: +44 01904 947568
Email support@coreservice.co.uk
Checking the chain brake
CAUTION: Hold the chain saw with both hands when switching it on. Hold the rear handle
with your right hand, the front handle with your left. The bar and the chain must not be in
contact with any object.
CAUTION: Should the saw chain not stop immediately when this test is performed, the
saw may not be used under any circumstances. Consult our authorised service center.
1. Press the lock-off switch, then pull the switch trigger. The saw chain starts immediately.
2. Push the front hand guard forwards with the back of your hand. Make sure that the chain saw
comes to an immediate standstill.
a b
2
a b
2
2. Front hand guard a. Unlocked position b. Locked position
Checking the run-down brake
CAUTION: If the saw chain does not stop within one second in this test, stop using the
chain saw and consult our authorised service center.
Run the chain saw then release the switch trigger completely. The saw chain must come to
a standstill within one second.
To Next Page
Loading...
