48
www.coreservice.co.uk
Hotline: +44 01904 947568
Email support@coreservice.co.uk
- After sharpening the chain, check the height of the depth gauge using the chain gauge tool
(optional accessory).
- Remove any projecting material, however small, with a special flat file (optional accessory).
- Round off the front of the depth gauge again.
Cleaning the guide bar
Chips and sawdust will build up in the guide bar groove. They may clog the bar groove and impair the
oil flow. Clean out the chips and sawdust every time when you sharpen or replace the saw chain.
To Next Page
Loading...
