Hayter H Series - Page 10

To check oil level:
Starting and Running Check List
Before you start
1/ Check that the engine is filled with the right oil (SAE 10W-30)
and to the recommended mark - never overfill, (see Fig. 3)
2/ Fill your petrol tank with fresh unleaded premium petrol (see
page 12) If it is more than 1/3rd full of old untreated petrol that
has been in the tank 8 weeks or more -drain and then refill. If less
than 1/3rd full of old untreated fuel, completely fill with new
premium unleaded petrol.
3/ Ensure the throttle is advanced to ‘Fast’ and, if engine is cold,
the choke is engaged.
4/ Ensure that the Park Brake is 'on’ or that the brake/clutch pedal
is fully depressed.
Insert the key and turn Clockwise
If dashboard ignition lights fail to come on - check
1/ That the battery terminals are connected, (see page 15 fig 21)
2/ That the 15amp fuse is properly located and has not blown
(see page 16 fig 25)
3/ That the battery is charged
If the engine falls to turn over - check
1/ That the brake is depressed or parking brake on.
If the engine turns over and does not start - check
1/ That the fuel tank Is full.
2/ That the spark plug lead is connected.
3/ That the outlet in the fuel tank is not blocked.
4/ That the spark plug is clean and set to the right gap
(see page15 fig 22).
5/ That the fuel filter is not blocked (See page 12 fig 12).
If the above do not apply - call your dealer.
If the engine misfires, loses power or stalls In use - check
1/ That you have not run out of fuel.
2/ That the air filter pre-cleaner is not blocked
(see page 13 figs 16 and 17).
3/ That the cooling air intakes are not blocked
(see page 13 figs 14 and 15).
4/ That the fuel filter is not blocked. (See page 12 fig 12).
5/ If the ignition lights have gone off check the 1 Samp fuse (see
page 16 fig 25)
IF THERE IS EVIDENCE THAT THE ENGINE IS OVERHEATING
OR IF YOU FIND THE OIL CONSUMPTION IS HIGH - CALL
YOUR DEALER WITHOUT FAIL
Ensure that the tractor is on a firm
level surface. Clean around oil filler. If
engine has been running wait a few
minutes after it has been turned ‘OFF’.
Turn anti-clockv</ise to remove.
Oil level should be in the grey zone.
If required, fill slowly then recheck.
10