Hayter H Series User Manual

H Series Tractor
Hints on use - Fault Finding -
Simple Maintenance
Hayter tractors leave the factory after a thorough inspection and Hayter dealers carry out a further
inspection before they deliver the tractor to you. All settings detailed in the following pages are correct
at the time of delivery. Wear, heavy use and accidental impact can change settings and the following
pages tell you how to carry out simple servicing and adjustments on the understanding that these are
carried out at your risk and that the consequences of incorrect servicing and adjustments are not
covered by warranty. If in doubt get your dealer to carry it out. Annual servicing by your dealer remains
a condition of the Hayter Two Year Limited Warranty.
tk
ENGINE
Check list - starting and running
Page 10
Oil level check
Page 10
Oil change and filters
Page 11
Fuel and Carburation
Page 12
Air and Cooling
Page 13
Transmission
Page 14
Electrical - Battery, Plugs and Lights
Page 15
Electrical ^ Fuses and PCB
Page 16
Wiring Diagram - Tractor H1538
Page 17
Wiring Diagram - H1842
Page 18
CUTTER
Check list - cutting faults
Page 19
Levelling the cutter - front to back
Page 20
Levelling the cutter - side to side
Page 21
Drive Belt Tension
Page 22
Deck Removal and Belt Replacement
Page 23
Integral Belt
Page 24
COLLECTOR
Check list - collection faults
Page 25
Drive Belt Tension and replacement
Page 26
Brush - replacement and maintenance
Page 27
TYRES
Check list
Page 28
Removal of wheels
Page 29
Puncture repair
Page 29
LUBRICATION AND GREASING
Steering, Rear Wheels and Cutter Deck
Page 30
9

Hayter H Series Specifications

General

Brand	Hayter
Model	H Series
Category	Tractor
Language	English