Hayter H Series User Manual

Check List
Not picking up satisfactorily - check:
1. That the PTO lever is engaged
2. That PTO pulley beneath the seat is turning -
if not, call your dealer
3. That the collector belt is not reversed (if it is
correct the brush revolves against the forward
direction of the tractor) (see below)
4. That the brush height adjustment Is not too
high or too low -start at the high setting and
lower until it begins to collect.
6. T hat there is not a build up of congealed
grass on the leading edge of the brush guard
(see page 27 fig 50)
6. That the brush is not clogged.
7. That the collector belt is not slipping. If so:
a/ Adjust tension (see page 26)
b/ Or replace worn or damaged belt
(see page 26)
8. That the collector net is not clogged
If so wash, or brush with a stiff hand brush.
9. That the brush is not damaged (If so you can
replace individual comb brushes or fit a
complete new brush (see page 27)
10. That the Ventilation Slots on the top of the
Collector Box are not clogged.
11. That the Venturi Air Vent is not blocked
USER TIPS-
If you are haying problems with build-up of
grass on the roller - reverse briefly at end of
each pass and you will drop the grass.
Insist that your sweeper is included in the
annual dealer service - next to the cutter deck
it is the hardest working part of your tractor.
Ensure that the Tipping Handle is kept clean
so it slides up and down easily - if it is left
sticking up it is prone to snag on branches etc

Hayter H Series Specifications

General

Brand	Hayter
Model	H Series
Category	Tractor
Language	English