Hayter H Series User Manual

Bearings on the Hayter Tractor are
sealed for life and do not require
greasing. There are just three
areas for your attention:
1. STEERING - A greasing point is
located at the base of the steering
quadrant, (see fig 64) Every month
use a grease gun to apply a lithium
based grease until it can be seen
coming out through the top of the
quadrant.
2. REAR WHEELS - Greasing
points are fitted to both rear wheeis
(see fig 55). Twice a year, remove
the hub caps and use a grease gun
to apply a lithium based grease until
grease can be seen coming out at
the washers. Replace the hub caps.
3. CUTTER DECK HANGER
BRACKETS - These must be kept
clean and lubricated to ensure the
cutter deck is free to move and ride
over bumps. Every month clean the
brackets (see fig 56) removing mud
and loose grass using an old
toothbrush then apply a good
general purpose grease.
CUTTER DECK HANGER BRACKETS
PERIODICALLY CHECK ALL NUTS AND BOLTS FOR TIGHTNESS
PAYING ESPECIAL ATTENTION TO THE SECURITY OF MAJOR
COMPONENTS; ENGINE, TRANSMISSION AND STEERING.

Hayter H Series Specifications

General

Brand	Hayter
Model	H Series
Category	Tractor
Language	English