Hayter H Series User Manual

1. Get on your tractor and make sure you are
comfortable and can reach all the controls.
Ensure that the RT.O. is disengaged and that
the parking brake is engaged. SELECT
NEUTRAL
2 . ADJUST THROTTLE CONTROL TO
FAST/CHOKE position for a cold engine or
an Intermediate position if warm. (The H1842
model has a separate choke).
3 . Insert key and TURN IGNITION TO THE
RIGHT (first position). The Ignition and Brake
indicator lights on the dash will illuminate
showing the tractor is ready to start - if the
lights do not illuminate ensure that the brake
is applied (there is a safety cut-out on the
brake),
4 . TURN IGNITION FURTHER to operate the
starter motor. If the engine does not start first
time, REPEAT
5 CANCEL ‘CHOKE’ AND SELECT FAST
SETTING when the engine is running well.
6 before you move off RAISE THE CUTTER
TO THE HIGHEST POSITION - this will
minimise the chances of damage whilst
moving to the area to be cut.
7. D E P R E SS CLUTCH/BRAKE TO CANCEL
HANDBRAKE.
8. HYDROSTATIC MODEL
Whilst still in neutral, release the park-brake
by pressing down the clutch/brake pedal.
Then move off by advancing the hydrostatic
speed control.
9 . When you have reached the area to be cut,
make sure the cutter is in the raised position
and nobody is near the tractor, then PUSH
THE CUTTER SWITCH UP briefly - you will
hear the cutters engaging.
10. SELECT CUTTING HEIGHT - Second or
third lowest for dry lawns, higher for wet or
long grass. Cut at slow or medium speed
settings on the hydrostatic speed control.
11. TO STOP CUTTING, RAISE CUTTER DECK
TO A HIGH POSITION and TURN THE
CUTTER SWITCH OFF (DOWN).
12. To park, first select a level area - then stop by
returning the speed control lever to neutral;
then apply the parking brake. AVOID
STOPPING ON SLOPES.
13 . ADJUST THROTTLE SETTING TO LOW,
ensure that the cutters and Power-Take-Off
are switched off AND THEN TURN OFF THE
IGNITION. Remove the key to prevent
unauthorised use - particularly by children.
LAYING UP YOMR TRACTOR,FOB THE WINTER
Your tractor should be serviced annually by your dealer - book it early to beat the last minute rush.
1. Ensure that the last fill of your petrol tank is clean fresh .unleaded fuel.
2. Having run the engine with the neW fuel either iri use or iferatle^^^ minutes, disconnect the battery, making sure
the terminal leads are removed and theh:DRAIN THE FUEL TANK. . 7 ^;
:g..Beconnect.ithebattery:iandls|ip^^^||J|(j^J^^^^J||jp|||lij^
4. WASH YOUR TRACTOR, takinig;partipuidr;^re the cutter deck and
6 . Lubricate theTractor and treat metal paiits w^ antl^brmsibn p^bductV^ I
7

Hayter H Series Specifications

General

Brand	Hayter
Model	H Series
Category	Tractor
Language	English