Hayward EcoStar SP3400VSP User Manual

32 pages

To Next Page

IS3400VSP Rev-B

Hayward Pool Products

620 Division St, Elizabeth, NJ 07201

Phone: (908) 351-5400

www.haywardnet.com

EcoStar

™

Owner’s Manual

Models SP3400VSP, SP3400VSPVR

EcoStar Variable Speed Pump

Hayward EcoStar is the industry’s most energy efficient variable speed pump. The totally enclosed,

permanent magnet motor combined with its advanced hydraulic design provides unparalleled energy

savings. EcoStar is easily installed either as a programmable stand-alone pump or with a Hayward or

third party controller and features an easy-to-use digital control interface that can be mounted in four

different positions on the pump or removed and mounted on the wall for total user convenience. The

EcoStar SVRS model provides an added layer of protection from suction entrapment without additional

devices, plumbing or wiring.

NOTE - To prevent potential injury and to avoid unnecessary service calls, read this manual carefully and

completely.

SAVE THIS INSTRUCTION MANUAL

Other manuals for Hayward EcoStar SP3400VSP

Technical Installation Guide43 pages

Questions and Answers:

L
linda98Sep 6, 2025
What does 'Drive Error! Drive Overload' mean on my Hayward Water Pump?
- R
  roseginaSep 6, 2025
  This error indicates that the motor is drawing excessive current. Check the impeller, diffuser, and shaft seal for any issues.
K
Kenneth HarrisonSep 8, 2025
What does 'Drive Error! AC voltage too low' mean on my Hayward Water Pump?
- J
  John ThomasSep 8, 2025
  This error indicates that the line voltage has dropped below 185 VAC, causing the pump to stop. Verify that the line voltage is within 10% of the pump's rated voltage.
T
Traci KennedySep 10, 2025
What does 'Drive Error! AC voltage too high' mean on my Hayward EcoStar SP3400VSP?
- V
  valerierossSep 10, 2025
  This error indicates that the line voltage has risen above 264 VAC, causing the pump to stop. Verify that the line voltage is within 10% of the pump's rated voltage.
J
Jeffrey ZhangSep 12, 2025
What does 'Drive Error! Heatsink overheated' mean on my Hayward Water Pump?
- W
  Wesley PattersonSep 12, 2025
  This error indicates that the heatsink of the drive has become overheated. Check the motor airflow path for obstructions and clear them. The pump will restart automatically once the temperature reaches an acceptable limit.
K
Kimberly HaynesSep 13, 2025
What does 'Drive Error! Drive failed to start' mean on my Hayward Water Pump?
- W
  webbjamesSep 13, 2025
  This error indicates that the drive was unable to start the motor. Verify the motor connections to the drive. The drive will attempt to restart the motor 3 times before displaying a pump stall error.

Hayward EcoStar SP3400VSP Specifications

General

Model	EcoStar SP3400VSP
Type	Variable Speed Pump
Horsepower	3.0 HP
Voltage	230V
Energy Efficiency	Energy Star Certified
Warranty	3 years
Control	Digital
Motor Type	Permanent Magnet
Speed Settings	Programmable