7: Check System
‘Stall error’ or ‘Drive Failed to Start’
With replacement drive run the pump on quick
clean for a minimum of 20 minutes to verify the
motor has not suffered any damage. If stall
reoccurs, replace the motor as well.
Inspect plumbing
If water damage is found in the motor OR the
pump is seized, replace the complete pump.
Prior to installing a new pump, fix any problems
that may cause future flooding or water damage.
Run with new drive
Step 8C Step 8D
Note: If water has flooded the drive or the motor, the repairs may not be covered under the product warranty.
For more information please consult the owner’s manual or contact a local Hayward representative.
Page 15
To Next Page
Loading...
