12
4. USER INTERFACE (continued)
At the end of a setting, press to validate.
The settings will be automatically saved if no button is pressed during 20s.
4.2 Clock settings
If the display is in standby mode, press briefly on .
1) Press
to bring up the symbol .
2) Press
to make the time display flash. Set the hour using the buttons
.
3) Press
then set the minutes with the buttons .
4) Press
to validate.
4.3 Timer function settings
Setting this function is necessary if you would like to run the heat pump for
a shorter period than what is defined by the filtration clock. Therefore, you
can program a deferred start and an anticipated stop or simply stop a certain
timeframe from running (at night, for example).
It is possible to set 2 Start Timers (ON1 et ON2) and 2 Stop Timers (OFF1 et
OFF2).
Timer 1 setting – Start
1) Press
for 2s, Timer ON1 flashes (*).
2) Press
to set the hours with the buttons .
3) Press
to set the minutes with the buttons .
4) Press
to validate.
Timer 1 setting – Stop
1) Press
for 2s, Timer ON1 flashes (*).
Press once, Timer OFF1 flashes.
2) Press
to set the hours with the buttons .
3) Press
to set the minutes with the buttons ..
4) Press
to validate.
(*) To access Timer ON2 directly, press for 2s, then press twice.
To Next Page
Loading...
Need help?
General