13
4. USER INTERFACE (continued)
Timers suppression (Start and Stop)
1) Press for 2s, Timer ON1 flashes.(*)
2) Press
to make the time display flash.
3) Press
to suppress the Timer .
4) Press
to validate.
5) Press
for 2s, the Timer flashes.
Press once , the Timer flashes.(*)
6) Press
to make the time display flash.
7) Press
to suppress the Timer .
(*) To access Timers 2
or , follow steps 1) or 4) then press
twice . Proceed in the same manner as above.
Timer 2 settings
After the Timer 1 settings, you will access directly the settings for Timer 2:
and .
Proceed in the same manner as for Timer 1.
Nota: To access directly Timer ON2 , press for 2s, then press
twice on
.
4.4 Operating mode selection
cooling, heating or automatic
In Mode “OFF” or “ON”
Press the button
to change mode: cooling, heating or automatic.
If the heat pump is set in heating only or cooling only, changing mode
is not possible.
To Next Page
Loading...
Need help?
General