12
FINE ADJUSTMENTS
Your Cleaner should move about
the pool without spending an
excessive amount of time against
the steps or other obstructions.
If the cleaner seems to get “hung
up,” turn the rear flapper adjuster
to Position I.
• Not Climbing the Walls or Stays on the Floor
• Sticking on Steps/Liner/Obstacles
If the Cleaner does not seem to be
“sticking” to the wall, turn the rear
flap adjuster to Position III.
• Sucking Air At Surface or Climbing Too High
SUCTION
SUCTION
13
Be aware that your Cleaner will climb the vertical walls in concrete
and fiberglass pools if there is at least a seven inch 180mm radius
where the walls and floor meet.
Due to the programmed steering, the Cleaner will not climb a wall
every time it comes into contact with one.
180mm +