Hayward Super Pump SP2607X10 User Manual

IS26001 Rev-B
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 1
Super Pump
®
700 Series
Owner’s Manual
IMPORTANT SAFETY INSTRUCTIONS
Basic safety precautions s
h
ou
ld
a
l
ways
b
e fo
ll
owe
d
, inc
l
u
d
ing t
h
e fo
ll
owing: Fai
l
ure to
f
o
ll
ow instructions
can cause severe injury and/or death.
This is the safety-alert symbol. When you see this symbol on your equipment or in this manual, look for
one of the following signal words and be alert to the potential for personal injury.
WARNING warns about hazards that could cause serious personal injury, death or major property
damage and if ignored presents a potential hazard.
CAUTION warns about hazards that will or can cause minor or moderate personal injury and/or
property damage and if ignored presents a potential hazard. It can also make consumers aware of
actions that are unpredictable and unsafe.
The NOTICE label indicates special instructions that are important but not related to hazards.
Hayward Pool Products
400 Connell Drive, Suite 6100, Berkeley Heights, NJ 07922
Phone: (908) 355-7995
www.hayward.com
Contents
Product Specific Warnings………2
Introduction……….………………..…4
Installation……….……………..….….7
Shaft Seal Replacement..………..8
Replacement Parts………….……..10
Troubleshooting………….…..…….11
Warranty…………………………………13
Registration ……………………..……15
Super Pump
®
Series

Hayward Super Pump SP2607X10 Specifications

General

Horsepower	1 HP
Voltage	115/230V
Speed	3450 RPM
Flow Rate	60 GPM
Port Size	1.5 inches
Phase	Single
Max Flow Rate	60 GPM
Discharge Size	1.5 inches
Suction Size	1.5 inches
Warranty	1 year
Motor Type	TEFC (Totally Enclosed Fan Cooled)

Summary

IMPORTANT SAFETY INSTRUCTIONS

Safety Alert Symbol and Signal Words

Explains the safety-alert symbol and signal words (WARNING, CAUTION, NOTICE) used in the manual.

READ, UNDERSTAND, AND FOLLOW ALL INSTRUCTIONS

Suction Entrapment Hazards

Details risks of hair, limb, body, and mechanical entrapment from suction outlets.

Reducing Entrapment Hazards

System Pressure and Separation Hazards

Warns about hazardous pressure and separation risks in circulation systems.

Risk of Electric Shock

Electrical Wiring Compliance and Safety

Covers NEC compliance, grounding, bonding, and GFCI protection for electrical safety.

Risk of Hyperthermia

Hot Tub Safety Rules and Hyperthermia Risks

Installation Instructions

Plumbing

Electrical

Electrical Wiring Compliance

Emphasizes conforming to local codes and NEC for electrical wiring.

Grounding and Bonding

Instructions for proper grounding and bonding of the pump for safety.

Wiring Requirements

Start-Up & Operation

Starting/Priming the Pump

Step-by-step guide for safely starting and priming the pump.

Troubleshooting

Motor Will NOT Start

Checks for issues preventing the motor from starting.

Motor Shuts OFF

Troubleshooting steps for a motor that shuts off automatically.

Motor Hums, But Does NOT Start

Pump Won't Prime

Checks for air leaks and blockages preventing the pump from priming.

Low Flow

Causes of Low Flow

Noisy Pump

Causes of Pump Noise