WARNING!
Read and understand the entire instruction
manual before attempting set-up or
13.
Keep
children and visitors away. Ali visitors
should be kept
a
safe distance from the work area
operation
,c,f
this mill/ drill
. 14 Make the workshop chi Id proof. Use padlocks,
------------------------
1. This machine is designed and intended for use
by properly
trained
and
experienced personnel
only.
If
you are not familiar with the proper safe use
of mill/drills, do not use this machine until proper
Training
and
knowledge has been obtained.
2. Keep guards in
place.
Safety guards must
be kept in place and in working order.
3. Remover adjusting keys and wrenches. Before
turning on machine, check to see that
any
adjusting
wrenches are removed from the tool.
4. Reduce the risk of unintentional starting.
Make
sure switch
is in the OFF position before
plugging in the tool.
5. Do not force tools. Always use a tool at the rate
for which it was designed.
6.
Use the right tool.
Do
not force
a tool or
attachment do
a
job for
which it
was not
designed.
7. Maintain
tools
with
care. Keep
tools sharp
and
clean for
best and
safest
performance.
Follow
. master switches and remove starter keys.
15.
Wear proper apparel. Loose
clothing,
gloves,
neckties, rings, bracelets, or other
jewelry
may
get
caught
in moving
parts. Non-slip footwear
is recommended. Wear protective
hair
covering
to contain long haïr. Do not
wear
any
glove.
16.
Always
use safety glasses. Also use face or
dust mask if cutting operation is dusty.
Everyday
eyeglasses only
have impact
resistant
lenses, they are not
safety glasses.
accessories may be hazardous.
17 Do not overreach. Keep proper footing and
balance
at ail
times.
18. Do not place hands near the
cutterhead
while the machine is operating.
19.
Do
not perform any set-up work while
machine is
operating.
20. Read and understand all warnings posted
on the machine.
instructions
for
lubrication
and
changing accessories.
21
This manual
is intended to familiarize you with
the
technical
aspects of
this mill/drill.
lt is
not,
8. Always disconnect the tools from the power nor was it intended to be, a training manual.
Source before adjusting or servicing.
22. Failure to comply with all
of
theses warnings
9. Check for damaged parts. Check for alignment
of
may
result in serious injury.
moving
parts, breakage of parts, mounting, and any
Other condition that may affect the tools operation. 23. Sorne dust created by power sanding, sawing,
grinding,
drilling and other
construction
activites
10.
Turn
power off. Never leave a tool unattended. contains chemicals
known
to
cause
cancer, birth
Do not leave a tool until it cornes to a complete stop. defects or
other
reproductive harm.
11. Keep work area clean. Cluttered areas and bench 24. Your risk from those exposures varies,
Invite accidents. depending on how often
you
do this type of work.
12. Do not
use in a dangerous environment.
Do not
Use power tools in damp or wet locations, or
expose
Them to
rain. Keep
work
area well
lighted.
- 3 -
To reduce
your
exposure
to
these
chemicals,
work in a
well
ventilated
are,
and work with
approved safety equipment
To Next Page
Loading...
