Need help?Do you have a question about the HBM MVD2510 and is the answer not in the manual?
Potential hazards from inappropriate use or by untrained personnel.
Discusses residual dangers and the responsibility of the system designer/operator.
Explains the structure and meaning of safety instructions and danger symbols.
Details ANSI danger classes, warning signs, signal words, and their significance.
Provides crucial safety precautions for device installation and operation.
Defines qualified personnel and their responsibilities for safe operation.
Instructions for connecting the device to the mains voltage supply.
Explains how to connect strain-gauge transducers using the 15-pin D-plug.
Details analogue output signals and control I/O connections.
Steps for initial system startup and enabling functional tests.
Explains the device's operating concept and keyboard functions.
Guides on setting limit values (Li1, Li2) in Measure mode.
Introduces the Programming mode for device setup.
Guides through the calibration process for the measurement system.
Explains parameters for setting limit values and their functions.
Setup for input signal, analogue output, and control contacts.
Shows factory settings for calibration parameters like nominal value and range.
Lists factory settings for limit values, source, direction, and hysteresis.
Error for transducer connection issues and remedy.
To Next Page
General
