Need help?Do you have a question about the HBM MX840B and is the answer not in the manual?
General| Number of Channels | 4 |
|---|---|
| Input Voltage Range | ±10 V |
| Signal-to-Noise Ratio | > 100 dB |
| Power Output | Not applicable (Instrumentation Amplifier) |
| Input Sensitivity | 10 μV |
Explanation of safety symbols used to indicate potential dangers.
Defines authorized personnel and rules on device alterations.
Overview of the different modules available in the QuantumX series.
Device and system assistant software for QuantumX module functions.
Professional software for data acquisition, analysis, and reporting.
Procedure for checking and updating module firmware using Ethernet.
Guidelines for connecting the DC power supply to the modules.
Establishing a connection to a PC using Ethernet for data transfer and control.
Setting up and using FireWire connections for PC communication.
Guidelines for connecting active transducers and using TEDS for sensor identification.
Introduction to MX840/A/B, MX440B, MX410B, MX430B, MX238B, MX460B amplifiers.
Wiring diagrams for full, half, and quarter bridge SG transducers.
To Next Page
