Quantum
X
I3031-14.0 HBM: public 3
English
1 Safety instructions 8........................................
2 Electro magnetic conformity 15...............................
3 Markings used 17............................................
3.1 The markings used in this document 17..........................
3.2 Symbols on the device 18......................................
4 Introduction 19..............................................
4.1 About the QuantumX documentation 19.........................
4.2 The QuantumX family 20......................................
4.3 Module overview/transducer technologies 24.....................
4.4 Digitalization and signal path 25................................
4.5 Synchronization 26............................................
5 Software 35.................................................
5.1 MX Assistant 35..............................................
5.2 catman®AP 37...............................................
5.3 LabVIEW® driver / library 38...................................
5.4 Driver for Microsoft® Visual Studio .NET 39......................
5.5 Other drivers 39..............................................
5.6 Firmware update via Ethernet 40................................
6 Mechanical 41...............................................
6.1 Mounting case clips on modules 42.............................
6.2 Connecting housings 45.......................................
6.3 Mounting the housing with CASEFIT 47..........................
6.4 BPX001/BPX002 backplane 47.................................
6.4.1 Connection 49................................................
6.4.2 Backplane BPX001 50.........................................
6.4.3 Backplane BPX002 52.........................................
6.4.4 Mounting the modules 52......................................
6.4.5 Backplane with Ethernet connection 56..........................
To Next Page
Loading...
