Need help?Do you have a question about the HBM AE301 and is the answer not in the manual?
Defines appropriate use, general dangers, environmental conditions, and maintenance/cleaning procedures.
Explains residual dangers, system safety responsibility, and defines DANGER, WARNING, and CAUTION symbols.
Details terminal assignments, functions, and cable colors for AE101, AE301, AE501 amplifiers.
Lists terminal assignments and functions for GR201, EM201, EM201K2, and TS101 units.
Details the setup procedure for AE101 measuring amplifiers, covering connection methods and internal settings.
Explains how to configure AE101 by setting bridge excitation voltage, measuring range, frequency, and zero point.
Covers the standard connection method and selecting bridge excitation voltage for AE301.
Details adjusting the measuring frequency range, setting the zero point, and selecting the measuring range for AE301.
Covers connection methods, bridge type selection using S27, and bridge excitation voltage selection for AE501.
Details adjusting the measuring frequency range, setting the zero point, and selecting the measuring range for AE501.
Explains how to adjust relay response points using potentiometers and measuring points for GR201.
Describes the two possible switching directions of the GR201 based on switch positions.
Explains the switch settings required for configuring ±20 mA and 4...20 mA current outputs for EM201/EM201K2.
To Next Page
General
