15
BOOST EQ FACILITY: Boost functions only work effectively if there is
sufficient of the frequency in order to be able to increase it. For critical
applications, EQ is generally thought to sound better where cut rather
than boosted. Most importantly with EQ is to use your ears!
3.2.1 BASS Control: +/- 12dB centred broadly @ 120Hz or +/- 16dB
@ 45Hz Allows control of the bass at the lowest frequency of the audio
spectrum and will over-lap a little tonally with LO MID control.
Controls the lowest frequency of the audio spectrum and will over-lap a
little with LO MID control. Cut BASS ACW to cut body handling noise,
boomy sounds, externally generated hum, percussive clunks and low
end feedback, as well as any instrument bias towards the low strings.
Increase Bass CW to beef-up tone or bias lower strings more strongly.
3.2.2 LO MID Control: +/- 13dB centred broadly @ 590Hz
Allows control of LO MID range which is centred above bass but below
UPPER MID.
Cut LO MID ACW to thin out tone or linearise or naturalise the tone of
many lower mid biased guitar pickups and speakers.
Cut LO MID to reduce body handling noise or over loudness on lower
strings, muddy or boomy sound.
Increase LO MID CW to thicken tone and increase bias towards lower
strings.
3.2.3 HI MID Knob: +/- 12dB centred broadly @ 880Hz
Allows control of UPPER MID range of frequency spectrum. Will
overlap a little tonally mainly with LO MID and Presence.
CUT UPPER MID ACW to thin out or hollow out tone, reduce bias of
middle guitar strings, remove honkiness, clunk, or peakiness.
INCREASE UPPER MID CW to thicken tone, add punch and increase
bias towards middle strings.
To Next Page
Loading...
