Healthrider H80t Treadmill User Manual (English)

Other manuals for Healthrider H80t Treadmill

Questions and Answers:

R
Rose WallerJul 30, 2025
What to do if Healthrider H80t Treadmill walking belt is off-center or slips?
- B
  bateskimberlyJul 30, 2025
  If the walking belt is off-center, remove the key and unplug the power cord. For a belt shifted to the left, turn the left idler roller screw clockwise 1/2 turn; if shifted right, turn it counterclockwise 1/2 turn. Plug in the power cord, insert the key, and run the treadmill briefly. Repeat until centered. If the belt slips, remove the key and unplug the power cord. Turn both idler roller screws clockwise 1/4 turn. The belt should be tight enough to lift each edge 2 to 3 inches off the platform, while keeping it centered.
M
Matthew SwansonAug 4, 2025
How to fix Healthrider H80t Treadmill that does not turn on?
- C
  Carolyn ColemanAug 5, 2025
  First, ensure the power cord is plugged into a surge suppressor, and the surge suppressor is plugged into a grounded outlet. Use a single-outlet surge suppressor meeting the required specifications. Note that the treadmill is not compatible with GFCI-equipped outlets and may not be compatible with AFCI-equipped outlets. After plugging in, ensure the key is inserted into the console. Also, check the power switch on the treadmill frame near the power cord. If it protrudes, the switch has tripped; wait five minutes, then press it back in to reset.
B
brittanythomasAug 9, 2025
Why Healthrider H80t Treadmill walking belt slows when walked on?
- R
  ryanwilliamsAug 9, 2025
  Your Healthrider treadmill has a walking belt coated with high-performance lubricant. Never apply silicone spray or other substances to the walking belt or the walking platform unless instructed by an authorized service representative, as these may deteriorate the walking belt and cause excessive wear. If you suspect that the walking belt needs more lubricant, see the front cover of this manual.
T
Tammie Heath DDSAug 14, 2025
Why does my Healthrider H80t power turn off during use?
- A
  Angel VaughnAug 14, 2025
  If your Healthrider Treadmill turns off during use, first check the power switch and press it back in. Also, ensure the power cord is properly plugged in. If it is, unplug it, wait five minutes, and then plug it back in.
J
Joseph BentonAug 19, 2025
What to do if Healthrider Treadmill console displays remain lit after removing the key?
- M
  Melissa GilbertSep 12, 2025
  The console may be in display demo mode, intended for use in stores. To turn off the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE INFORMATION MODE on page 23 to turn off the demo mode.
M
Mary WilliamsAug 25, 2025
What to do if Healthrider H80t Treadmill console display has lines running through it?
- T
  Taylor WillisAug 25, 2025
  If lines appear in the console display, see THE INFORMATION MODE on page 23 and adjust the contrast level of the display.

Healthrider H80t Treadmill Specifications

General

Running Area	20" x 55"
Maximum User Weight	300 lbs
Display	Multi-window LED display
Programs	20 Workout Apps
Heart Rate Monitoring	Dual-Grip EKG Heart Rate Monitor
Folding	SpaceSaver Design with EasyLift Assist
Running Surface	20" x 55"
Weight Capacity	300 lbs
Incline	0% to 12%
iFit Compatibility	Yes
Speed Range	0 – 12 MPH
Incline Range	0% to 12%
Decline	No