Healthrider L400i Treadmill HRT07920 User Manual (English)

Questions and Answers:

D
Debra ChaseJul 29, 2025
What to do if Healthrider Treadmill power does not turn on?
- A
  Anthony BeckJul 29, 2025
  If your Healthrider Treadmill does not turn on, ensure the power cord is plugged into a surge suppressor and that the suppressor is plugged into a grounded outlet. Make sure the key is fully inserted into the console. Check the circuit breaker located near the power cord; if the switch protrudes, wait five minutes, then press it back in to reset. Also, verify the on/off switch is in the on position.
M
Mark CastroAug 3, 2025
How to fix Healthrider L400i HRT07920 Treadmill walking belt off-center or slips?
- M
  Melissa TuckerAug 4, 2025
  If the Healthrider Treadmill walking belt is off-center, remove the key and unplug the power cord. If the belt has shifted left, turn the left rear roller bolt clockwise 1/2 turn. If it has shifted right, turn the bolt counterclockwise 1/2 turn. If the belt slips, remove the key and unplug the power cord. Turn both rear roller bolts clockwise 1/4 turn. Properly tightened, you should be able to lift each side of the belt 3 to 4 inches off the walking platform.
M
Mary FernandezAug 9, 2025
How to recalibrate incline on Healthrider L400i HRT07920 Treadmill?
- M
  Megan WeberAug 9, 2025
  To recalibrate the incline on your Healthrider Treadmill, insert the key into the console and press one of the Incline buttons. While the incline is changing, remove the key. After a few seconds, re-insert the key. The treadmill will automatically rise to the maximum incline level and then return to the minimum level.
A
Andrew WhiteAug 14, 2025
Why Healthrider L400i HRT07920 power turns off during use?
- T
  Tracy MosleyAug 14, 2025
  If your Healthrider Treadmill turns off during use, check the circuit breaker located on the treadmill frame near the power cord. Also, ensure the power cord is properly plugged in; if so, unplug it, wait five minutes, and plug it back in. Remove and re-insert the key fully into the console, and verify that the on/off switch is in the on position.
T
Thomas HaynesAug 18, 2025
Why Healthrider L400i HRT07920 walking belt slows when walked on?
- R
  Robert BondAug 18, 2025
  If the Healthrider Treadmill walking belt slows down when you walk on it, ensure you are using a single-outlet surge suppressor meeting the specifications described on page 8 of the manual. If the belt is overtightened, remove the key and unplug the power cord. Then, using an allen wrench, turn both rear roller adjustment bolts counterclockwise 1/4 of a turn. When properly tightened, you should be able to lift each side of the belt 3 to 4 inches off the platform.
T
Teresa LewisAug 23, 2025
What to do if Healthrider Treadmill speed display does not function properly?
- D
  Donald TuckerAug 23, 2025
  If the speed display on your Healthrider Treadmill console isn't working, remove the key and unplug the power cord. Locate the Reed Switch and the Magnet on the left side of the Pulley. Turn the Pulley until the Magnet aligns with the Reed Switch. Slightly move the Reed Switch and retighten the Screw. Re-attach the hood, and run the treadmill briefly to check the speed reading.