Healthstream T401 - Assemble the Upright Post

8 Owner’s Manual
Use Hex wrench to perform this assembly procedure.
1. Connect the cables (E, F) before you assemble the upright post (C
)
to base frame (K).
2. Lightly secure the upright post (C, D) to base frame (K, J) with
four
M8x15mm screws (A) and four flat washers (B) on two sides.
3. Tighten the eight bolts on the upright post after they are in position.
Take care that the
cables do not get
trappe
d or pinched.
NOTE
1. ASSEMBLE THE UPRIGHT POST
STEP BY STEP INSTRUCTION
K
J