14 • NuWave PIC Complete Cookbook
Troubleshooting
Solution
Error
Message
E2
E3
E4
E5
E6
E7
E8
FULL
E1
The unit is malfunctioning. Contact customer service.
The unit is malfunctioning. Contact customer service.
The unit is malfunctioning. Contact customer service.
An E1 reading typically means that your PIC does not detect
cookware on its surface. This can occur for one of two
reasons.
1. Have you placed a pot or pan on the unit? The induction
coils contained within the PIC will only work when they are
in direct contact with a piece of cookware. To maintain your
appliance’s effectiveness, always ensure that it rests on a at
surface and that contact is consistent with your cookware.
2. An E1 message may also occur if your chosen cookware is
not induction-ready.
The units voltage is too low. Minimum = 85 volts
The units voltage is too high. Maximum = 144 volts
Overheating, or air ventilation is obstructed. If internal
temperature exceeds 230˚ F, operation will cease and a “beep”
noise will be produced. Press “Pause/Clear” twice. Wait for the
unit to cool.
In programming mode, when the total entered time reaches
the appliance’s limit of 99:60, no additional stages can be
inputted.
Overheating, if unit exceeds a temperature 20º F higher than
sear, the appliance will turn off. Contact customer service.
• When any of the above error messages display on the LED, the unit will “beep” at least once.
• The fan will run up to a maximum of 60 seconds after pressing the “Pause/Clear” button
once. Continue cooking by pressing the “Start” button within 45 minutes.
• The unit will turn off after 45 minutes if no buttons (such as “Start”) are pressed. When
the unit shuts off, it will clear all previous cooking history.
• After pressing the “Pause/Clear” button twice or cooking has stopped, the fan will run up
to a maximum of 60 seconds until the unit cools. At that point the PIC will turn off.
• When an E1 error occurs, the unit will “beep” every 2 seconds. If the PIC has not detected
a pot after 1 minute, it will shut off automatically. In order to resume cooking before automatic
shutoff, place induction-ready cookware on the PIC’s surface. The E1 error message and
“beep” sound will continue, even after cookware has been replaced, until the “Pause/Clear” or
“Start” buttons have been pressed.
To Next Page
Loading...