EasyManua.ls Logo

Heat & Glo Heat-N-Glo 6000XLS User Manual

Heat & Glo Heat-N-Glo 6000XLS
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
1
- Do not store or use gasoline or other flam-
mable vapors and liquids in the vicinity of this
or any other appliance.
- What to do if you smell gas
Do not try to light any appliance.
Do not touch any electrical switch.
Do not use any phone in your building.
Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
If you cannot reach your gas supplier, call
the fire department.
- Installation and service must be performed by a
qualified installer, service agency, or the gas
supplier.
Heat-N-Glo
Models:
6000TR
6000XLT-CDN
6000ARCH
6000XLS
Installers Guide
WARNING: IMPROPER INSTALLA-
TION, ADJUSTMENT, ALTERATION,
SERVICE OR MAINTENANCE CAN
CAUSE INJURY OR PROPERTY DAM-
AGE. REFER TO THIS MANUAL. FOR
ASSISTANCE OR ADDITIONAL INFOR-
MATION CONSULT A QUALIFIED IN-
STALLER, SERVICE AGENCY, OR THE
GAS SUPPLIER.
525-983C 1/00
READ THIS MANUAL BEFORE INSTALLING OR
OPERATING THIS APPLIANCE. THIS INSTALL-
ERS GUIDE MUST BE LEFT WITH THE APPLI-
ANCE FOR FUTURE REFERENCE.
1. This appliance may be installed in an
aftermarket, permanently located,
manufactured (mobile) home, where not
prohibited by local codes.
2. This appliance is only for use with the
type of gas indicated on the rating plate.
This appliance is not convertible for use
with other gases, unless a certified kit is
used.
Please contact your Heat-N-Glo dealer for any
questions or concerns. For the number of your
nearest
Heat-N-Glo dealer, please call 612-985-6000.
Printed in U.S.A. Copyright 2000,
Heat-N-Glo, a division of Hearth Technologies Inc.
20802 Kensington Boulevard, Lakeville, Mn 55044
WARNING: IF THE INFORMATION
IN THESE INSTRUCTIONS IS NOT
FOLLOWED EXACTLY, A FIRE OR
EXPLOSION MAY RESULT
CAUSING PROPERTY DAMAGE,
PERSONAL INJURY, OR DEATH.
Underwriters
Laboratories Listed
1
This product is covered by one or more of the following patents: (United States) 4,112,913; 4,408,594; 4,422,426; 4,424,792; 4,520,791; 4,793,322;
4,852,548; 4,875,464; 5,000,162; 5,016,609; 5,076,254 5,191,877; 5,218,953; 5,328,356; 5,429,495; 5,452,708; 5,542,407; 5,613,487; (Australia)
543790; 586383; (Canada) 1,123,296; 1,297,746; 2,195,264; (Mexico) 97-0457; (New Zealand) 200265; or other U.S. and foreign patents pending.

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Heat & Glo Heat-N-Glo 6000XLS and is the answer not in the manual?

Heat & Glo Heat-N-Glo 6000XLS Specifications

General IconGeneral
TypeGas Fireplace
Ignition SystemElectronic Ignition
Vent TypeDirect Vent
Glass TypeCeramic Glass
Log Set MaterialCeramic Fiber
WarrantyLimited Lifetime Warranty
Fuel TypeNatural Gas or Propane
Control TypeRemote Control

Summary

SAFETY AND WARNING INFORMATION

Approvals and Codes

Appliance Certification

Details on testing and listing by applicable laboratories.

Installation Codes

Conformance to local building codes and national fuel gas codes.

High Altitude Installations

Approved elevations and input rating adjustments for high altitudes.

Getting Started

Introduction to Heat-N-Glo Gas Fireplaces

Overview of direct vent gas fireplaces and their operation.

Pre-installation Preparation

Steps to take before starting installation, checking components.

Installing the Fireplace

Locating the Fireplace

Space and clearance requirements for fireplace placement.

Framing the Fireplace

Guidelines for framing the fireplace opening and vent pipe clearances.

Installing the Vent System

Covers vent system approvals, components, and terminations.

Positioning, Leveling, and Securing

Proper methods for placing, leveling, and securing the fireplace unit.

Gas Control Systems

Overview of Standing Pilot Ignition and Direct Spark Ignition systems.

Gas Supply Line Installation

Instructions for connecting the gas supply line to the fireplace control valve.

Gas Pressure Requirements

Specifies minimum and maximum inlet and manifold gas pressures.

Wiring the Fireplace

Electrical wiring requirements for ignition systems.

Finishing the Fireplace

Guidelines for non-combustible facing and trim installation.

Installing Trim, Logs, and Ember Material

How to install trim, position logs, and place ember material.

Before Lighting the Fireplace

Checklist of tasks before the initial lighting of the fireplace.

Lighting the Fireplace

Procedures for safely lighting the gas fireplace.

Heating Control (Model 6000XLT-CDN)

How to adjust the baffle lever to control heat output.

Relief Ports (Model 6000ARCH)

Explanation of the relief port and safety microswitch system.

Fireplace Maintenance

Maintenance Schedule and Tasks

Frequency and procedures for maintenance tasks.

Related product manuals