63
TROUBLESHOOTING
PART 12: TROUBLESHOOTING (CONTINUED)
this error occurs at any time other than when a technician is servicing the unit, the control has failed
and must be replaced by a qualified technician.
Remedy:
Control must be re-programmed. If programming does not solve problem, control must be replaced.
Fault Code PP
CONTROL PROGRAMED
PP
Description:
The control has been programmed by a technician or the factory. After programming, the control is
left in a locked out mode. Press the ‘RESET’ key to begin use of the control.
Remedy:
Press S4 reset for at least 1 second.
To Next Page
Loading...
