Heathkit AR-14 - Circuit Board Component Placement

- Heathkit
START
NOTE: 1/ 4 watt resistors, a diode,
and a wire will be installed on the
right-hand side of the circuit board
in the following steps.
( ) 3300 þÿ© (orange-orange-red).
H-"[5 00 þÿ© (brown-green-red).
( ) 3300 þÿ© (orange-orange-red).
( ) 47 þÿK© (yellow-violet-orange).
( .-}-- 5600 n (green-blue-red).
( -•r 1500 n (brown-green-red).
( -.l- lo---Kn (brown-black-orange).
( -) Diode (brown-white-brown).Po-
sition the banded end as shown.
NOTE: Do not confuse the band-
ed end with the copper colored
wire that is visible inside the
diode.
· ·. ~:J1r::tll1:t:r>·
+-+--33 n (orange-orange-black).
i.:1----1-1 ~00 n (green-blue-red).
N--68oo n (blue-gray-red).
00 n (brown-black-red).
( '-Yl 50 n (brown-green-brown).
(~ n (orange-orange-black).
( _L Solder all leads and clip off
the excess lead lengths.
PICTORIAL 2
Page 7
CONTINUE
Q
~ 600 n (green-blue-red).
( ..)..-½-500 n (brown-green-red).
<
.)-1-QOO n (brown-black-red).
) 1" bare wire. Use one of the
cut-off resistor leads.
(A 270 n (red-violet-brown).
.!-}- 270 n (red-violet-brown).
( ...Jf 1200 n (brown-red-red).
( ...r,:- 1000 n (brown-black-red).
(A 470 n (yellow-violet-brown).
( ~ 1500 n (brown-green-red).
( #) 68 Kn (blue-gray-orange).
( ff 10 Kn (brown-black-orange).
( ~ 2200 n (red-red-red).
(P ) 220 n (red-red-brown).
Solder all leads and clip off the
excess lead lengths.
PROCEED TO PICTORIAL 3.