Heathkit AR-14 - Installation

2
I
Page 50
~fH#iffHQ
INSTALLATION
The Receiver can be installed in either of the
following Heathkit Accessory Cabinets: The
AE-55 Walnut Cabinet , or the AE-65 Metal
Cabinet.
mounted without a cabinet in either a vertical
or horizontal position. If the Receiver is cus-
tom mounted, it may be necessary to remove the
plastic feet before mounting it. Always mo unt
the Receiver so the weight is not supported by
the front panel. See Figure 7.
If preferred, the Receiver can be custom
® PREPARING SHELF FOR RECEIVER
FRONT
PANEL
MOUNTING
SURFACE
_ -;-_-=. ·~ - q~NTING SURFACE -_ - -:-- ~·-=--- · -- _-
-
NOTE: THESE FOUR CORNER HOLES LINE UP WITH THE MOUNTING
FOOT HOLES IN THE RECEIVER
BOTTOM PANEL .
USE FOUR SHEET METAL SCREWS TO SECURE RECEIVER TO SHELF.
MOUNTING RECEIVER , SHELF ,
AND SHELF SUPPORT .
@,.._ ____ ~
/?
(';\ MOUNTING RECEIVER IN
\V VERTICAL POSITION
(§)
\\ @
\\
I
-----8 - 15 / 16 " -----1"
8 -1 s / 1 6" 1 "
10 - 1 / 2"
PANEL
J
Figure 7