Heathkit AR-14 - Chassis Mounting Details

Page 14
START
•
NOTE: When installing electrolytic
capacitors, position the positive (+)
marked end of the capacitor over the
positive (+) mark lettered on the
circuit board.
100 µfd, 30 volt electrolytic.
:rnf ,,····' · '·'·'·''·'··· '<
!11111/. .,.,.,:;!:!;l;ili;:,'.::::J!ililllllllliii[i!llllii
( ""t--10 µfd, 10 volt electrolytic.
( ---) 100 µfd, ..L.YQ!1 electrolytic.
f--}_ .0068 µfd resin,
··.·-:-:-::::::::::::::::::::::· >-=••,;,:~~: :"?\:
N 10 µfd, 15 or 20 volt electro- 1-----·"" '' ~"7::..:t"t.t.."t~
lytic. \
( )
Solder all leads to the foil and
cut off the excess lead lengths.
.0022 µfd resin.
µfd, 10 volt
µfd, 10 volt electrolytic.
2_ µfd, 25 volt electrolytic.
2 µfd, 25 volt electrolytic,
2" jumper wire. Use a length of
rown wire with a 1/4" of insula-
tion removed from each end.
( ) Solder all leads to the foil and
cut off the excess lead length.
I
::::::;t
//\ :¥,,;~;;;;;;;.;;;.;;;;;;;'?': i'
PICTORIAL 9
"
CONTINUE
0
µfd, 10 volt electrolytic,
µfd, 15 or 20 volt electro-
lytic.
electrolytic,
.0068 µfd resin.
'--L Solder all leads to the foil and
cut off the excess lead lengths,
electrolytic,
10 µfd, 10 volt electrolytic,
100 µfd, 30 volt electrolytic,
100 µfd, 30 volt electrol ·
Solder all leads to the foil an.
cut off the excess lead lengths
FINISH
PROCEED TO PICTORIAL 10.