Heathkit IO-4205 - Page 20

Page 18
The steps performed in this Pictorial are
in this area of the circuit board.
......--~
START•
) Reposition the circuit board as
shown. Solder
the pins to the foil !DENT! FICA TION
as you install each part.
ORA WING
NOTE: When you install an IC socket,
insert the pins
into the circuit b.oard
holes.
The index mark on the circuit
board must still be visible after the
socket is installed.
IC socket at QlOlA.
in IC socket at Q102A.
in
IC socket at U102.
14-pin
IC socket at U101.
Q
~
nc=:>
~I
PART
NUMBER
PICTORIAL 1-7
CONTI NU Ev
NOTE: When you install a control, in-
sert
the pins into the circuit board
holes
and solder them to the foil.
~
1 .. .. ~ ...
.... .• ,.;ip'i''>
100 n control (#10-357).